Compressed air & nitrogen heaters

Heat Pro HP200

A compressed air heater that increases productivity and efficiency. Achieve consistent heat and reduce material waste with in-line heating at the spray gun.

100°F – 180°FUp to 16 cfm110 / 220 VACUL · CSA · ETL · CE
HeatPro 200 heater controller with heated hose and spray gun
Why the HP200

Consistent heat for every coat

01

Waterborne & solvent

Ideal for spray-painting both waterborne and solvent-based materials.

02

Full temperature control

Built-in set value and present value temperature controller gives maximum user control.

03

Right heat for each coat

Adjustable temperatures for sealer, primer, base and clear coats.

04

Air or nitrogen

Heats compressed air, or nitrogen from a NitroMax generator, in-line at the spray gun.

Installation

Setting up your HP200

  1. One HP200 is required for each spray booth or prep station.
  2. Mount upright, outside the spray booth.
  3. Connect the regulator to the heater controller input, then the heated hose, thermocouple connector and heater power cables to the top of the heater.
  4. Route the heated hose through the booth wall and add a quick connect for the spray gun.
  5. Switch on, check the green LED, temperature controller and multimeter, then set the temperature.
  6. Switch off at night.

Hose thermocouple connector: it fits one way only, so check the polarity. If the temperature drops when air flows, the connector is reversed. Never disassemble the heated hose, and don't drive over it.

Full installation notes →
Recommended NitroHeat installation layout
Recommended layout: one HP200 per booth or prep station.
Prices (MSRP, USD)

HP200 & heated hose

  • HP200HeatPro 200 heater controller
    $4,770
  • NHH5050 ft heated hose (connects to the HP200)
    $789.50
  • NM15Complete single booth system: N2 generator with 1 × HP200 and 1 × NHH50
    $26,705

All prices exclude shipping, installation and training. Full price list & finance →

Technical specifications

HeatPro 200 at a glance

Product code
HP200 (HeatPro 200)
Description
N2 heater controller
Heater wattage
500 W
Operating temperature
100°F – 180°F
Electrical
110 / 220 VAC, 50–60 Hz
Current draw
7.5 A
Max inlet pressure
120 psi (8.2 bar)
Pressure drop
< 5 psi (0.3 bar)
Max flow rate
16 cfm (450 LPM)
Enclosure
ABS
Dimensions (H × W × D)
16 × 10 × 6 in (406 × 254 × 152 mm)
Connections
½" FNPT inlet, ½" MNPT outlet
Filtration
Optional
Shipping weight
17 lb (7.7 kg)
Made in
USA
Certifications
UL, CSA, ETL, CE
All technical specifications →

Add heated spraying to your booth

Use the HP200 with compressed air today, or pair it with a NitroMax generator for heated nitrogen.

CallGet a Quote